亚洲日韩精品无码首页明星_理论三级无码视频_2020国产成人精品视频_精品无码不卡一区二区三区

歡迎光臨深圳阿爾法商品檢驗有限公司
24小時服務熱線
4008-3008-95

加拿大ISEDCRSS-247 issue 1&2新舊兩版標準的 主要差異

2017-04-12 11:30:50
文章出處:深圳阿爾法商品檢驗有限公司    作者:Admin    瀏覽次數:4369

加拿大ISEDCRSS-247 issue 1&2新舊兩版標準的


主要差異



RSS-247, Issue 2 will be in force as of its publication on Innovation, Science and Economic Development Canada’s (ISED) website. However, a transition period of six (6) months following its publication will be provided, with in which compliance with RSS-247, Issue 2, or Issue 1,will be accepted. After this period, only applications for certification of equipment under RSS-247, Issue 2, will be accepted.

加拿大IC認證之藍牙,wifi等無線局域網設備標準RSS-247第二版于2017年2月23日發布,過渡期6個月。在此過渡期內可接受新舊標準的測試報告,過渡期后只能按照新版標準測試。



主要變化

首先各個章節小序號原來是1,2,等數字,現在改為a,b等字母排序。

1.New section 3.3: state the requirement for emissions that fall within restricted frequency bands to comply with the provisions in RSS-Gen, General Requirements for Compliance of Radio Apparatus;

新增3.3章節,要求禁用頻段內的無意輻射應滿足RSS-Gen中要求。


2.Section 5.4(b): reinstated the former e.i.r.p. limit for frequency hopping systems operating in the band2400-2483.5 MHz, which employ a hopset with less than 75 channels;

章節5.4(b)設備使用信道小于75個的 e.i.r.p.限值為4W,舊標準要求是0.5W。


3.Section 6.2: add a clarification to ensure that emissions that fall within restricted frequency bands shall comply with the provisions in RSS-Gen;

6.2章節要求禁用頻段內的輻射應滿足RSS-Gen中要求。



4.Section 6.2: state the measurement method for power and unwanted emission limits for licence-exempt local area network devices and digital transmission systems operating in the 5  GHz band;

6.2章節規定了工作在5GHz頻段設備的檢測方法,頻段的帶寬要求推薦應以99%OBW為主。


5.Section 6.2.1 and 6.2.2: add a provision to allow original equipment manufacturer (OEM) devices installed in road vehicles to operate in the band 5150-5250 MHz with an e.i.r.p. limit of 30 mW or 1.76 + 10 log10B, dBm, whichever is less stringent;B is the 99% emission bandwidth in megahertz.

章節6.2 允許OEM使用頻段band 5150-5250 MHz和 5250-5350 MHz開發車載產品,產品須符合e.i.r.p限值30 mW 或 1.76 + 10log10B, dBm,限值取兩者最嚴格值;B 值為99%的輻射占用帶寬,單位為MHz。


6.Section 6.2.1.2: clarify the requirement for devices operating in the band 5150-5250 MHz, which have bandwidth that falls into the band 5250-5350 MHz;

章節6.2.1.2 進一步澄清工作頻段在5150-5250 MHz設備無用輻射要求,5150-5350 MHz帶外輻射限值為-27 dBm/MHz e.i.r.p.如果5250-5350 MHz內的無用輻射低于信道功率26dB占用的帶寬落在此頻段內,可認為其輻射為其有意輻射,并須滿足5250-5350 MHz內設備的所有要求,包括DFS,TPC等要求。


7.Section 6.2.2.2 (b): permit the requisite "for indoor use only" notice for equipment operating in the band5250-5350 MHz to be included in the user manual;

工作在5250-5350 MHz內的設備,章節6.2.2.2(b)最后一句話”shall belabelled or include in the user manual the following text “for indoor use only.”,要求警示語“for indoor use only.”放到說明書中或設備標簽上,老標準只要求張貼在設備標簽上。


8.Section 6.2.2.3: apply     the requirement of e.i.r.p. at different elevations for equipment operating in the band5250-5350 MHz to outdoor fixed devices only;

工作在5250-5350 MHz內的設備,新增額外要求在章節6.2.2.3中,針對戶外產品最大e.i.r.p.超過200mW的情況,增加在不同角度的測量要求;非戶外產品最大e.i.r.p.超過200mW,須滿足6.6.6.3 b i) 或 ii) 。


9.Section 6.2.4.2: modify the unwanted emission limits for LE-LAN devices and DTS operating in the band5725-5850 MHz;

更詳細的規定了6.2.4.2章節的無用輻射要求。


10.Annex A: delete the word  "pre-installation" to clarify that the verification of e.i.r.p. compliance at different elevations for devices operating in the band 5250-5350 MHz needs to be done at the time of certification (before installation); the verification of compliance must be submitted with the test report for equipment requiring certification.

附錄A中去掉"pre-installation"。