RSS-247, Issue 2 will be in force as of its publication on Innovation, Science and Economic Development Canada’s (ISED) website. However, a transition period of six (6) months following its publication will be provided, with in which compliance with RSS-247, Issue 2, or Issue 1,will be accepted. After this period, only applications for certification of equipment under RSS-247, Issue 2, will be accepted.
加拿大IC認證之藍牙，wifi等無線局域網設備標準RSS-247第二版于2017年2月23日發布，過渡期6個月。在此過渡期內可接受新舊標準的測試報告，過渡期后只能按照新版標準測試。
Listed below arethe changes:
主要變化：
首先各個章節小序號原來是1，2，等數字，現在改為a,b等字母排序。
1.New section 3.3: state the requirement for emissions that fall within restricted frequency bands to comply with the provisions in RSS-Gen, General Requirements for Compliance of Radio Apparatus;
新增3.3章節，要求禁用頻段內的無意輻射應滿足RSS-Gen中要求。
2.Section 5.4(b): reinstated the former e.i.r.p. limit for frequency hopping systems operating in the band2400-2483.5 MHz, which employ a hopset with less than 75 channels;
章節5.4（b）設備使用信道小于75個的 e.i.r.p.限值為4W，舊標準要求是0.5W。
3.Section 6.2: add a clarification to ensure that emissions that fall within restricted frequency bands shall comply with the provisions in RSS-Gen;
6.2章節要求禁用頻段內的輻射應滿足RSS-Gen中要求。
4.Section 6.2: state the measurement method for power and unwanted emission limits for licence-exempt local area network devices and digital transmission systems operating in the 5 GHz band;
6.2章節規定了工作在5GHz頻段設備的檢測方法，頻段的帶寬要求推薦應以99%OBW為主。
5.Section 6.2.1 and 6.2.2: add a provision to allow original equipment manufacturer (OEM) devices installed in road vehicles to operate in the band 5150-5250 MHz with an e.i.r.p. limit of 30 mW or 1.76 + 10 log10B, dBm, whichever is less stringent;B is the 99% emission bandwidth in megahertz.
章節6.2 允許OEM使用頻段band 5150-5250 MHz和 5250-5350 MHz開發車載產品，產品須符合e.i.r.p限值30 mW 或 1.76 + 10log10B, dBm,限值取兩者最嚴格值；B 值為99%的輻射占用帶寬，單位為MHz。
6.Section 6.2.1.2: clarify the requirement for devices operating in the band 5150-5250 MHz, which have bandwidth that falls into the band 5250-5350 MHz;
章節6.2.1.2 進一步澄清工作頻段在5150-5250 MHz設備無用輻射要求，5150-5350 MHz帶外輻射限值為-27 dBm/MHz e.i.r.p.如果5250-5350 MHz內的無用輻射低于信道功率26dB占用的帶寬落在此頻段內，可認為其輻射為其有意輻射，并須滿足5250-5350 MHz內設備的所有要求，包括DFS,TPC等要求。
7.Section 6.2.2.2 (b): permit the requisite "for indoor use only" notice for equipment operating in the band5250-5350 MHz to be included in the user manual;
工作在5250-5350 MHz內的設備，章節6.2.2.2（b）最后一句話”shall belabelled or include in the user manual the following text “for indoor use only.”,要求警示語“for indoor use only.”放到說明書中或設備標簽上，老標準只要求張貼在設備標簽上。
8.Section 6.2.2.3: apply the requirement of e.i.r.p. at different elevations for equipment operating in the band5250-5350 MHz to outdoor fixed devices only;
工作在5250-5350 MHz內的設備，新增額外要求在章節6.2.2.3中，針對戶外產品最大e.i.r.p.超過200mW的情況，增加在不同角度的測量要求；非戶外產品最大e.i.r.p.超過200mW，須滿足6.6.6.3 b i) 或 ii) 。
9.Section 6.2.4.2: modify the unwanted emission limits for LE-LAN devices and DTS operating in the band5725-5850 MHz;
更詳細的規定了6.2.4.2章節的無用輻射要求。
10.Annex A: delete the word "pre-installation" to clarify that the verification of e.i.r.p. compliance at different elevations for devices operating in the band 5250-5350 MHz needs to be done at the time of certification (before installation); the verification of compliance must be submitted with the test report for equipment requiring certification.
附錄A中去掉"pre-installation"。
如需更多關于加拿大無線標志，請致電 0755-29766001-8033 無線事業部
